End your motors sticky valves, sticky piston rings, lifters quickly, safely. Restore smooth, quiet, powerful motor zip in minutes guaranteed.
Sticky valves: Our review. The problem, and the only guaranteed product known to clean, free, and quiet the noise - safely, in minutes.
There are 3 problems causing your motors sticking valves, sticky valve lifters, and sticky piston rings
Each time you change your oil a gooey film remains behind.
Cooking hot combustion blow-by mixes with your motor oil and turns it into gooey sludge.
Hot, dirty blow-by, and exhaust emissions are recirculated into the combustion cycle - a big contributor.
Those three negatives, like tar on a hot sticky tin roof, are coating your motors 8 to 24 engine valve stems, their head, or the hydraulic lifters that push them up and down.
Those conditions cause sticking and binding and your motor problem.
Which products free, clean, end the problem the safest way? I'll show you the best one to use.
To end your sticky valves,
And sticky piston rings, and lifters quickly and safely, and restore its former great power, I recommend the
valve, lifter, and piston-ring cleaning treatment
from Mega Power.
This product will end the problem that usually cost over $1500 to remedy. For under $100, the Mega Power Treatment will chemically free, clean, and end sticking valves in minutes. You can install it your self. Its easy. Even women have done it.
This is a typical compliment I get from customers.
"Just 5 minutes after I installed the Mega Power Treatment in the motor, it cough a little, then smooth right out. The sticking problem just went away."
" My motor ran rough and stalled occasionally. It was as noisy as my mothers sewing machine. As we added the treatment, the motor just simply smooth right out and quieted down. Its never ran better. Thanks George for a great tip on what to use."
The cleaning process and ingredients
In this product, is a little different from most. And the method of simple installation does a super cleaning job. One that normally a mechanic would do taking apart and hand cleaning each valve to end the problem.
The valve, lifter, and piston-ring cleaning treatment
I call it the
Mega Power Sticky Valves Cleaning Treatment .
While not like the actual repair, is more than good enough to keep your motor clean for many, many years.
And at a lower cost of $1500 or more if a mechanic took your motor apart to end the problem. What the treatment consist of is this...
It takes 6 products to end your sticky valve problem
3 for the top side of the motor to go wherever air, fuel and exhaust go, and 3 for the oil - bottom side of your motor. Cleaners and friction modifiers and anti-wear coatings do the job as you drive.
Its the right method of engine care for people who want a good service product that also helps extend the life of their motor.
That is the easiest, cheapest, fastest way to end your sticking valve - and other, problem-causing engine wear problems.
I've installed it in hundreds of my customers cars with the same great results. Its a great car care invention.
The details and ordering info is on the link page below.
You will have Happy Motoring and an end to your worry about you motor problem with this Mega Power Treatment.... george.
Mega Power Sticky Valves Cleaning Treatment