Ending valve lifter tapping noise is now done in 2 different ways. One avoids an expensive repair. But is it for you?

valve lifter noise, tap, valve additive

Today, you start your car.... And this time, a tapping sound occurs - tap tap tap - it won't go away. You raises and lower the motor speed - it still is sounding like some mechanic left a wrench inside your motor. The tap is loud enough to hear inside your car. What now, you wonder?

You glance at the oil change sticker, you have 2000 miles to go on your oil. You check the oil level - its OK. And the color shows it shouldn't be worn out!

You got to get to work. On the freeway you're doing alright, but the noise is still there. Or, it may come and go. You're wondering: "What does the tap indicate? And what will it cost me - to fix it.

Valve lifter noise and motor tapping is the result of sticky residues blocking oil delivery to your motor's valves and their lifters -  How new products ends the noise.

Causes of valve lifter noise

  • When new, and for a number of years afterwards, you engine valves - there are 2 for each cylinder, let fuel into your engine combustion area and let spent combustion - exhaust out, without a whimper of their presence heard in your motor.
  • Those parts work with near zero space. However, due natural restraints, valve wear is the most rapid of your engine and gear wearing parts.
  • Because wear is a factor critical to your cars full horsepower development - meaning, wear reduces the amount of fuel going into your motor, and therefore, reduces the horsepower develop. Valves need to be adjusted every few years to keep your motor's zip and power as it should be.
  • To save this costly maintenance, and the tie-up of the car for day in the shop, automatic valve adjusters were added to take up this space, by the car makers.

The start of valve lifter noise

  • Residues also will stick the adjusters - called valve lifters,  in such a way the adjuster part will collapse.
  • When that happens a space appears, and with each motor revolution you hear that space close up with a bang - heard as a tap tap tap.
  • Residues form as your motor's sticky piston rings allow some gas and some combustion to slip pass the pistons and this "blowby" mixes with your oil. As that mix occurs sludge forms in your motor's oil.
  • With circulation, residues will travel an end up in your valve lifters and valve stems. Residues will then block oil to the adjusted - oil under pressure raises the lifter adjuster as needed.
  • Blockage, like a tire with a nail hole in it, causes the lifter to collapse. The resulting space causes the tap.

You now know more about valves and why valve lifter noise occurs than your mechanic! 

The two ways of ending your motor valve lifter noise

  1. The mechanic's repair way. The common method is to pay a mechanic to dismantle the top half of your motor. Dirty valve parts removed require machining to clean-them-up. Deeper in the motor your motor's many hydraulic lifters are yank out like a dentist pulling teeth, new lifters installed, and your motor reassembled, as the fix. Cost $1500 to $3500.
  2. The other way is to install a new product called Mega Power. Mega Power works due to its 6 item treatment of very powerful cleaners. Anyone can easily install Mega Power to end their motor tap. Shown here. Mega Power ends valve lifter noise.

The Mega Power Valve Lifter Treatment installs easily to  clean and free your stuck or sluggish valve or lifter condition - the cause  of the tap - sometimes in a few minutes, to a day of driving, customers tell us. That's my experience, too! And the best part - with this valve lifter tapping remedy, there is nothing to take apart! Driving does the fix!

Directions: The valve treatment works in 2 steps like this. Step One. You add 3 items for top of motor valve cleaning. One to the gas tank, to the oil, and vacuum for top of the motor valve cleaning. Drive as usual.

Step Two. A week later you add the 3 remaining items during an oil change. That takes away the cause of the problem and smooth, very powerful quiet smoothness - amazingly returns!

Pretty simple for a complex problem. These 6 items work together from 6 directions found to clean, condition and end the tap. Driving does the actual fix. Most times, the tap stops right away. Total cleaning of the 2 steps ends the problem permanently. 

Mega Power will add years more quiet, dependable life to your motor at a much lower expense than repair, at $250 if a mechanic installs it for you. Under $100 if you install it yourself. If you read this far, you need to order Mega Power. Order online or by phone.

Ends valve lifter  noise.

Ordering Info

  • Order one Mega Power Valve Treatment. Includes 6 items shown. Easy-to-follow directions. Phone help if wanted. Satisfaction Guarantee. Shipped to your door by FedEx in 3 days. Just $75, plus $15 s&h= $90 total. 
  • Order 2 Treatments to protect both your cars, save $30. 12 items. $115+ $15s&h=$130 total. Not $160. Order for both cars to protect them, now, since you're thinking about it! Save $30.
  • Order 6 Mega Power Treatments to service 6 motors. Fleet or mechanics resale value. 36 items. $300+ $20s&h=$320 total. Not $450. Order now! Save $130.


You motor tap is caused by one of 3 negative conditions

  1. Your motor's dirty fuel intake valves, or exhaust valves - or valve adjusters - nicknamed lifters cause the noise. When so dirty, movement slows down their snappy up and down closing speed. Tapping results
  2. Or causes the adjuster to drop. Both problems creates a space and the tap as they bang against each other related part.
  3. So, if not dirty valves, its your motor's dirty valve lifters sticking such,  a space occurs, causing the tap.

Using Mega Power you clean and free all 3 areas of the tap ends your motor valve lifter noise and tapping.

Dirty rings, valves, and lifters indicates the dirtiness is about to cut your engine life in half! You don't want to go there, do you? No!

The tap is caused by another dirty condition called "blowby"

You can blame your tapping and years shorter engine life from dirty, lazy piston rings. They allow boiling-hot 500 degree combustion gases to slip pass your motor's piston's, to mix-in with your motor's oil. Sound good to you? No, its not!

Oil break-down forms [a sludge], circulating in a gravy-like goo.

That tar-like goo is what coats your valves making them slow closing, and blocks oil flow needed to keep your valves hydraulic lifters [adjusters] tight and quiet operating.

When sludge blocks oil flow to the lifters, lifters collapse, a space develops, and the tap tap tap sound appears. Get it? Complicated - right?

Well, the point being, sludge is caused by blow-by  and is the 3rd causes of valve tap - and Mega Power ends all 3 dirty problems for you, you thought your good oil was suppose to do - but, can't!

How Mega Power Stops valve lifter noise for good!

The Mega Power Valve Treatment uses 6 items to get to, and remove what the best oils cannot - sticky residues on piston rings, motor valves, and valve lifter adjusters to end the blow-by and tap problem. We made it easy to install. Is that what your after? Order Mega Power below.

The install of Mega Power is simple, although Mega Power performs a complex, Hi-tech cleaning and freeing action, no synthetic oil can ever do. 3 Mega Power items shown go in the top gas, air and combustion side of the motor, and 3 into the motor's oil during an oil change, to end your tap work.

A remedy that ends the tap when nothing else can. No special skill needed, nothing to take apart. Just add as directed, and driving does the fix, quieting the tap - guaranteed!

Mega Power comes by FedEx to your door in about 3 days, with easy-to-follow directions, phone help if needed, and our guarantee. You can order the Mega Power Valve Treatment below.

Ordering Info

Order one Mega Power Valve Treatment. Includes 6 items shown. Easy-to-follow directions. Phone help if wanted. Satisfaction Guarantee. Shipped to your door by FedEx in 3 days. Just $75, plus $15 s&h= $90 total.

Order 2 Treatments to protect both your cars, save $30. 12 items. $115+ $15s&h=$130 total. Not $160. Order for both cars to protect them, now, since you're thinking about it! Save $30.

Order 6 Mega Power Treatments to service 6 motors. Fleet or mechanics resale value. 36 items. $300+ $20s&h=$320 total. Not $450. Order now! Save $130.

The treatment contains 6 items. 3 for the top part of your motor. 3 installed a week later during an oil change. Driving does the actual fix. These 6 have proven to be what works best to quickly end lifter tapping.

As you can see, this is your motor and budget saver. A good invention. Order it today, and get on down the road of life again, much happier.

Mega Power Ends Valve Lifter Noise.


What you should know: Treatment Advantages

This Mega Power Valve Treatment ends the valve lifter noise when nothing else can and ends several more wear, residue conditions that would soon cause other costly-to-repair problems - to boot!

That should be good news to you, if you're on a tight budget - and who isn't, these days?

Easy to use. Driving does the actual valve lifter noise fix

The easy-to-use Mega Power Product uses 6 special new ingredients for the fix.

Each ingredient penetrates a different problem area. See valve illustration and video, below.


There, they clean, free, heal, and smooth the affected valve - ending the problem - as you drive.

Customers who installed the Treatment - like Mike, tell us, about his valve-lifter-noise. Mega Power works as described. Order Mega Power Now.